Stratux: To Pull the Plug or Not to Pull , That is the Question!

iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsADS-B Discussio...ADS-B Discussio...Stratux: To Pull the Plug or Not to Pull , That is the Question!Stratux: To Pull the Plug or Not to Pull , That is the Question!
Previous
 
Next
New Post
7/14/2018 8:24 AM
 

I've been cruising the AP forums and there is conflicting and confusing information about whether it is adviseable to simply "pull the plug" to turn off a Stratux or whether it should have a "soft" shutdown via a software command which I believe is now available on the latest iteration of iFly software.

"Pulling the plug" has been alleged to cause Stratux software and/or card corruption, etc.  However, I had also heard that Chris Young, the developer of Stratux, routinely "pulls the plug" during the thousands of Stratux development cycles and says it is not a problem.  I was concerned because I remotely mounted my Stratux (it is not accessible from the pilot's seat) to replace my NavWorx box and power it via a 3A/5V UBEC wired to my avionics master.  I routinely "pull the plug" by shutting down my avionics master and have had no problems. I recently was corresponding with Chris and asked him about the conflicting advice.  Here's his email response to me (emphasis mine):

 

Hi John,

 It's fine to pull the plug. Earlier Pis (Raspberry Pi 1) had issues with SD card corruption, so this idea that one must safely shut down the Pi is pretty well ingrained for many people. With the Pi3 and a decent quality SD card, there should not be a problem.

 I don't really encourage users to do a "safe shutdown". The main reason is that some battery packs actually do the opposite. You shut down the unit via software, the power consumption goes to zero, the battery pack shuts down. After a few seconds, the battery pack "forgets" and senses a load is connected, then re-starts the unit!

Hope that helps,

Chris

 

So there you have it from whom I consider the single most authoritative source for Stratux information!

John

N750A

(Apologies to Will Shakespeare!)

 
New Post
7/14/2018 11:43 AM
 

I routinely turn off my "radio" switch before shuting down the engine (the stratux is on that circuit), without problems at all, since day one with the stratux, never had any problems.

I never did a "soft" shutdown. 

Ciao

 
New Post
7/14/2018 2:33 PM
 
I'm not sure why we keep asking and answering this question, but you may or may not ever have a problem. If you don't want to shut down properly, which I don't, why not make a back-up of your micro SD card, which I did.
 
New Post
7/14/2018 2:59 PM
 
JohnnyBlackCT wrote:
I'm not sure why we keep asking and answering this question, but you may or may not ever have a problem. If you don't want to shut down properly, which I don't, why not make a back-up of your micro SD card, which I did.

That's my whole point ... "pulling the plug" IS not only a "proper shut down" of Stratux, it is the method recommended by it's developer, who ought to know!  :>)  Sometimes obsolete advice gets perpetuated on the 'net, which is apparently the case with so many saying you "must" do a soft shutdown to avoid card corruption problems, etc., despite what Chris says.

As far as software/card corruption problems, I've read that this is mainly due to people being sold "fake" name-brand micro SD cards, when they think they are getting a quality card.  It pays to be very careful to get authentic cards.

And that's great advice - I always carry both a Stratux backup on a micro SD card and an iFly backup SD card for my 740!

John

 
New Post
7/14/2018 3:32 PM
 
A computer file can become corrupted if it is being written to disc at the instant you "pull the plug." It happens.
 
Previous
 
Next
HomeHomeDiscussionsDiscussionsADS-B Discussio...ADS-B Discussio...Stratux: To Pull the Plug or Not to Pull , That is the Question!Stratux: To Pull the Plug or Not to Pull , That is the Question!